FERTILISER DISTRIBUTOR, OTHER TYPE WITH REG. TEEJET 5000 OPERATORS MANUAL
4.16
KG: Consumption in Kg since the last reset
in DATA/DELETE.
KG LEFT: KG remaining in the hopper (amount
filled must be encoded before start).
RPM 1: Shaft speed of axle 1.
KG: Kg consumed, measured via the pulse generator on the sow axle.
This function presupposes correct calibration of the system
(amount per pulse).
KG LEFT: The amount remaining in the hopper. Presupposes encoding the
amount filled before start (done in encode).
RPM 1: Shaft speed of axle no. 1.
Pressing the “NEXT PAGE” key displays the last available functions.
RPM 2: Shaft speed of axle no. 2 (sow axle).
Pressing the “NEXT PAGE” key displays the first available functions.
SECTION ON/OFF:
The picture to the left shows a spreader with 2 sections
encoded, where one is open and one is closed. The total
number of sections is set under encode.
I
When the area override sensor is activated (not counting
area) “I” is displayed and all sections will disappear.
To Next Page
Loading...