SLURRY SPREADER, HORSCH TEEJET 5000 OPERATORS MANUAL
7.30
TON/M3
REST: The amount remaining in the tank. This function presupposes
encodement of the tank size “TANK VOLUME” in encode. Every
time “TANK EMPTY” is pressed, the tank size is transferred to
“TON/M3 REST” and the slurry spreader is ready to fill and
spread again.
This function is also used in conjunction with flowmeter calibration
(see page number 7.34)
(TON/M3)/MIN: The amount of slurry per minute going through the flowmeter.
Pressing “NEXT PAGE” displays the next possible functions.
+XX%: Step dosage, increase.
-XX%: Step dosage, decrease.
NORMAL: Return to the required normal
application rate.
DOSE RATE: Encoding the required application rate.
+XX%: Percentile increase of the encoded application rate. The size of
the steps is altered in encode.
-XX%: Percentile reduction of the encoded application rate. The size of
the steps is altered in encode.
NORMAL: (Only displayed if the step feature has been used)
Normal application rate. Regardless of how many steps the
application rate has been increased/decreased by, pressing this
key will return the application rate to normal.
DOSE RATE: Pressing this key allows the application rate to be altered directly
from the operation screen (see also DOSE RATE in encode).
Pressing the “NEXT PAGE” key displays the next functions.
RPM 1: Revolutions per minute.
RPM 1: The shaft speed of an axle is displayed here. Normally the RPM of
the distributor/macerator.
Pressing the “NEXT PAGE” key displays the first set of functions.
To Next Page
Loading...