Cisco NCS 2006 - NTP-L33 Installing the Power Module in the NCS 2002 Shelf

Step 2
Connect the wire wrap cable to the appropriate timing connector in the Power Module.
Step 3
Connect the other end of the cable to the external source of the timing.
Repeat this step for each cable that is needed.
Step 4
Return to your originating procedure (NTP).
DLP-L55 Installing Timing Wires in Cisco NCS 2002- ETSI
This task installs the timing wires in the AC-2 or
DC-2E Power Module of NCS 2002 (ETSI).
Purpose
Cisco NCS 2000 Series Hardware Installation Guide
98
Connecting and Routing the Cables and Wires
DLP-L55 Installing Timing Wires in Cisco NCS 2002- ETSI