Cisco NCS 2006 User Manual

NTP-L62 Installing the SFP Module on the NCS 2015 ECU
Use this procedure to install the SFP module in the
SFP ports (M-MSM-2, P-MSM-2, M-MSM-3, and
P-MSM-3 ports) of the NCS 2015 ECU.
The only supported SFP is
ONS-S1-100-FX.
Note
Purpose
•
Wrist strap or other personal grounding device
to prevent electro-static discharge (ESD)
occurrences.
•
Antistatic mat or antistatic foam to set the SFP
on.
•
Fiber-optic end-face cleaning tools and
inspection equipment.
•
Multi-mode optical fiber
•
ONS-S1-100-FX pluggable
Tools/Equipment
None.Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
SFP modules are Class I laser products. Statement 1008Warning
Because invisible laser radiation may be emitted from the aperture of the port when no cable is
connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 70
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
Use of controls, adjustments, or performing procedures other than those specified may result in
hazardous radiation exposure. Statement 1057
Warning
Cisco NCS 2000 Series Hardware Installation Guide
412
Multishelf Management
NTP-L62 Installing the SFP Module on the NCS 2015 ECU

Cisco NCS 2006 Specifications

General

Brand	Cisco
Model	NCS 2006
Category	Network Hardware
Language	English