During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Warning
Always use the supplied ESD wristband when working with a powered NCS 2002, NCS 2006, or NCS
2015 shelf assemblies. For detailed instructions on how to wear the ESD wristband, refer to the Electrostatic
Discharge and Grounding Guide for Cisco NCS 2000 Series.
Caution
If you install a card incorrectly, the FAIL LED flashes continuously.Note
Procedure
Step 1
Complete DLP-L62 Installing the TNC, TNCE, TSC, TSCE, TNCS, or TNCS-O Card, on page 400.
Step 2
Complete DLP-L63 Provisioning PPM and Port for the TNC,TNCE, and TNCS Cards, on page 404 .
Step 3
Complete DLP-L64 Configuring UDC and VoIP for the TNC, TNCE, TNCS, and TNCS-O Cards, on page
405 .
Stop. You have completed this procedure.
DLP-L62 Installing the TNC, TNCE, TSC, TSCE, TNCS, or TNCS-O Card
This task installs redundant
TNC/TNCE/TSC/TSCE/TNCS/TNCS-O cards on
the NCS 2006 shelf, a stand-alone
TNC/TNCE/TSC/TSCE card on the NCS 2002 shelf,
and redundant TNCS/TNCS-O cards on the NCS
2015 shelf. Install and initialize the
TNC/TNCE/TSC/TSCE/TNCS/TNCS-O card before
installing any other line cards into the shelf
assemblies. On the NCS 2006 shelf, install the
TNC/TNCE/TSC/TSCE/TNCS/TNCS-O cards in
slots 1 and 8 for redundancy. On the NCS 2002 shelf,
install the stand-alone TNC/TNCE/TSC/TSCE card
in slot 1. On the NCS 2015 shelf, install the
TNCS/TNCS-O cards in slots 1 and 17 for
redundancy.
Purpose
Cisco NCS 2000 Series Hardware Installation Guide
400
Installing and Configuring the Control Card
DLP-L62 Installing the TNC, TNCE, TSC, TSCE, TNCS, or TNCS-O Card
To Next Page
Loading...
Need help?
General
