CHAPTER 2
Preparing to Install the Cisco NCS 2002, NCS
2006, and NCS 2015 Shelf
This chapter explains how to prepare for the Cisco NCS 2002, NCS 2006, and NCS 2015 shelf install.
The sections are:
•
Important Safety Recommendations, page 9
•
Required Tools and Equipment, page 10
•
Ordering Solutions for NCS 2002, NCS 2006, and NCS 2015, page 16
•
Card Slot Requirements, page 16
•
NTP-L41 Unpacking and Inspecting the Shelf, page 20
Important Safety Recommendations
This warning symbol means danger. You are in a situation that could cause bodily injury. Before
you work on any equipment, be aware of the hazards involved with electrical circuitry and be
familiar with standard practices for preventing accidents. To see translations of the warnings that
appear in this publication, refer to the Regulatory Compliance and Safety Information document
for the appropriate Cisco chassis. Statement 274
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074Warning
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or
2) while the housing is open, or both. Statement 1043
Warning
Cisco NCS 2000 Series Hardware Installation Guide
9
To Next Page
Loading...
Need help?
General
