Cisco NCS 2006 - External LAN Interface for EMS; TL1 Craft Interface; Modem Interface; Alarm Interface

External LAN Interface for EMS
The NCS 2006 external LAN interface has the following specification:
•
10/100BaseT Ethernet located on the ECU or ECU2 and supports:
TL1 Craft Interface
The NCS 2006 TL1 craft interface has the following specifications:
•
Speed: 9600 bps
•
TNC/TNCE/TSC/TSCE access: EIA/TIA-232 DB-9 type connector
•
An alternative RJ-45 LAN connector on TNC/TNCE/TSC/TSCE or ECU or ECU2
Modem Interface
The NCS 2006 modem interface has the following specifications:
•
Hardware flow control
•
TNC/TNCE/TSC/TSCE: EIA/TIA-232 DB-9 type connector
Alarm Interface
The NCS 2006 alarm interface has the following specifications:
•
2 SCSI Connectors located on the ECU or ECU2
•
Visual: Critical, Major, Minor, Remote
•
Audible: Critical, Major, Minor, Remote
•
Alarm inputs: Common 32-VDC output for all alarm-inputs, closed contact limited to 2 mA
•
Control outputs: Open contact maximum 60 VDC, closed contact maximum 100 mA
Passive Unit Remote Inventory
The NCS 2006 provide 12 standard USB ports located on the ECU or ECU2 to retrieve the inventory data
from the passive units.
BITS Interface
The NCS 2006 building integrated timing supply (BITS) interface has the following specifications:
•
2 T1 BITS inputs wire wrap for applications
Cisco NCS 2000 Series Hardware Installation Guide
468
Hardware Specifications
External LAN Interface for EMS