Plug one connector into:
a
a
M-MSM-1 port of NCS 2015 SSC that corresponds to the control card in Slot 1
b
MSM port of NCS 2006 SSC that corresponds to the control card in Slot 1.
c
RJ-45 port of the control card in Slot 7 of ONS 15454 SSC.
b
Plug the other end into Port 2 of the active Catalyst 3560.
c
Using a cross-over (CAT-5) LAN cable, plug one connector into:
a
P-MSM-1 port of NCS 2015 SSC that corresponds to the control card in Slot 17
b
MSM port of NCS 2006 SSC that corresponds to the control card in Slot 8.
c
RJ-45 port of control card in Slot 11 of ONS 15454 SSC.
d
Plug the other end into Port 2 of the standby Catalyst 3560.
5
To configure the active and standby Catalyst 3560, complete the NTP-L63 Configure a Cisco Catalyst
3560 (Active and Standby) for a Multishelf Node, on page 413
Cisco NCS 2006 Node Controller, and ONS 15454, NCS 2006, and NCS 2015
Subtending Shelves
When a Cisco NCS 2006 shelf is used as the node controller, a mix of 15 ONS 15454, NCS 2006, and NCS
2015 shelves can be subtended. The maximum number of NCS 2015 shelves that can be subtended is 10.
Scenario 1: Using RJ-45 and SFP MSM-M and MSM-P Ports, ONS 15454, NCS 2006, and NCS
2015 SSCs Can Be Connected To the NCS 2006 NC.
1
Install the SFP module in the SFP ports of the ECU in NCS 2015 SSCs. For more information, see NTP-L62
Installing the SFP Module on the NCS 2015 ECU, on page 412.
2
Using a cross-over (CAT-5) LAN cable:
a
Plug one connector into the MSM port of the NCS 2006 NC that corresponds to the control card in
Slot 1.
b
Plug the other end into the MSM port of the NCS 2006 SSC 1 that corresponds to the control card in
Slot 1.
3
Using another cross-over (CAT-5) LAN cable:
a
Plug one connector into the MSM port of the NCS 2006 NC that corresponds to the control card in
Slot 8.
b
Plug the other end into the MSM port of the NCS 2006 SSC 1 that corresponds to the control card in
Slot 8.
4
Using a cross-over (CAT-5) LAN cable:
a
Plug one connector into the MSM port of the NCS 2006 NC that corresponds to the control card in
Slot 1.
Cisco NCS 2000 Series Hardware Installation Guide
427
Multishelf Management
Cisco NCS 2006 Node Controller, and ONS 15454, NCS 2006, and NCS 2015 Subtending Shelves
To Next Page
Loading...
Need help?
General
