CHAPTER 14
Mounting the Cisco NCS 2006 Shelf
This chapter explains how to mount the Cisco NCS 2006 shelf.
The sections are:
•
ANSI Rack Installation, page 185
•
ETSI Rack Installation, page 187
•
NTP-L3 Mounting the NCS 2006 Shelf, page 189
ANSI Rack Installation
The NCS 2006 shelf is mounted on a 19-inch (482.6-mm) or 23-inch (584.2-mm) equipment rack. Make sure
that the correct type of 19-inch ANSI rack is used for mounting the NCS 2006 shelf. If the shelf is mounted
in the front position, then it projects 1.7 inches (43.18 mm) from the front of the rack. If the shelf is mounted
in the middle position, then it projects 5.1 inches (129.54 mm) from the front of the rack. The shelf mounts
in both Electronic Industries Alliance (EIA) standard and Telcordia-standard racks. The shelf is a total of 17
inches (431.8 mm) wide with no mounting ears attached. Ring runs are not provided by Cisco and might
hinder side-by-side installation of shelves where space is limited.
The NCS 2006 shelf measures 10.4 inches (264.16 mm) high, 19 or 23 inches (482.6 or 584.2 mm) wide
(depending on which way the mounting ears are attached), and 11.1 inches (304.8 mm) deep. You can install
up to seven NCS 2006 shelves in a 7-foot (2133.6 mm) equipment rack.
Cisco NCS 2000 Series Hardware Installation Guide
185
To Next Page
Loading...
Need help?
General
