Cable and Fiber Routing
Cable and fiber routing accommodates all the high-density cards for line card connections in NCS 2015. The
exit of the fibers and cables is split into two channels. The line card from slot 1 to 8 exits from the lower left
side, and the line card from 9 to 17 exit from the lower right side. (See the figure below)
Figure 199: Cable and Fiber Routing in NCS 2015 DC Shelf
NTP-L55 Routing and Locking Cable and Fiber Modules
TThis procedure routes and locks the cables on the
NCS 2015 system.
Purpose
#1 Phillips cross-head PH screwdriverTools/Equipment
NonePrerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Cisco NCS 2000 Series Hardware Installation Guide
348
Connecting and Routing the Cables
Cable and Fiber Routing
To Next Page
Loading...
