Cisco NCS 2006 User Manual

NTP-L14 Attaching Wires to Alarm, Timing, LAN, and Craft Pin
Connections
Use this procedure to attach alarm, timing, LAN, and
craft wires in the NCS 2006 shelf.
Purpose
Twisted #22 or #24 AWG (0.51 mm² or 0.64 mm²)
shielded wires for LAN or craft 75-ohm coaxial cable
with DIN-1.0/2.3 miniature coaxial connector, Alarm
26 pins SCSI cable.
Tools/Equipment
NTP-L8 Install the NCS 2006 ECU and ECU-S
Modules, on page 277
Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Always use the supplied ESD wristband when working with a powered NCS 2006. For detailed instructions
on how to wear the ESD wristband, see the Electrostatic Discharge and Grounding Guide for Cisco NCS
2000 Series.
Caution
Procedure
Step 1
Complete DLP-L26 Installing Alarm Wires in NCS 2006, on page 230 if you are provisioning external alarms.
Step 2
Complete DLP-L27 Installing Timing Wires on NCS 2006 - ANSI, on page 235 if you are provisioning
external timing in .
Step 3
Complete DLP-L28 Installing Timing Wires in NCS 2006 - ETSI, on page 237 if you are provisioning external
timing in ETSI.
Step 4
Complete DLP-L29 Installing LAN Wires in NCS 2006, on page 240 to create an external LAN connection.
Table 12: PIDs for SCSI Cables
Wire DimensionLengthPIDCable
28 AWG20 Meter15454-M-ALMCBL=SCSI alarm cable
28 AWG1 Meter15454-M-AEXPCBL=SCSI alarm patch cable
24 AWG20 Meter15454-M-ALMCBL2=SCSI alarm wire-wrap
cable
Cisco NCS 2000 Series Hardware Installation Guide
229
Connecting and Routing the Cables
NTP-L14 Attaching Wires to Alarm, Timing, LAN, and Craft Pin Connections

Cisco NCS 2006 Specifications

General

Brand	Cisco
Model	NCS 2006
Category	Network Hardware
Language	English