Cisco NCS 2006 User Manual

NTP-L22 Cleaning Fiber Connectors
This procedure cleans the fiber connectors.Purpose
Inspection microscope
Type A Fiber Optic Connector Cleaner (CLETOP
reel)
Optical swab
Optical receiver cleaning stick
Tools/Equipment
NonePrerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector.
Do not view directly with optical instruments. Viewing the laser output with certain optical
instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm
may pose an eye hazard. Statement 1056
Warning
Procedure
Step 1
Using an inspection microscope, inspect each fiber connector for dirt, cracks, or scratches.
Step 2
Replace any damaged fiber connectors.
Replace all dust caps whenever the equipment is unused for 30 minutes or more.Note
Step 3
Complete DLP-G262 Cleaning Fiber Connectors with CLETOP, on page 453 as necessary.
Step 4
Complete DLP-G263 Cleaning the Fiber Adapters, on page 454 as necessary.
To clean multi-fiber optic connectors, complete the DLP-G261 Cleaning Multi Fiber-Optic Cable
Connectors, on page 452 as necessary.
Note
Stop. You have completed this procedure.
DLP-G261 Cleaning Multi Fiber-Optic Cable Connectors
This task cleans the multi fiber optic connectorsPurpose
Cisco NCS 2000 Series Hardware Installation Guide
452
Maintaining the NCS 2002, NCS 2006, and NCS 2015 Shelves
NTP-L22 Cleaning Fiber Connectors

Cisco NCS 2006 Specifications

General

Brand	Cisco
Model	NCS 2006
Category	Network Hardware
Language	English