Cisco NCS 2006 User Manual

Step 4
Align the screw holes on the mounting brackets with the mounting holes in the rack.
Step 5
Have one person hold the shelf in place while the other person uses the Phillips Dynamometric screwdriver
to install one mounting screw in each side of the assembly. Tighten the screw to a torque value of 22 in-lb
(2.5 N-m).
Step 6
When the shelf is secured to the rack, install the remaining mounting screws.
Step 7
Return to your originating procedure (NTP).
DLP-L74 Mounting Multiple NCS 2015 Shelves on a Rack
This task installs multiple shelves in a rack.Purpose
•
#2 Phillips Dynamometric screwdriver
•
ETSI: 16 M6 x 20 mm pan-head Phillips
mounting screws
•
ANSI: 16 #12-24 x 0.50 inch pan-head Phillips
mounting screws
Tools/Equipment
NTP-L48 Mounting Brackets on NCS 2015 Shelf for
ANSI Rack Configuration, on page 303
Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
A standard rack can hold three NCS 2015 shelves. When mounting a shelf in a partially filled rack, load
the rack from the bottom to the top with the heaviest component at the bottom of the rack. If the rack is
provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.
Note
The NCS 2015 shelf requires 24.4 inches (619.76 mm) minimum of vertical rack space.Note
Procedure
Step 1
Verify that the proper fuse and alarm panel has been installed in the top mounting space. If a fuse and alarm
panel is not present, you must install one according to manufacturer’s instructions:
•
For a DC power supply, the fuse rating must not exceed 60 A.
Cisco NCS 2000 Series Hardware Installation Guide
323
Mounting the Cisco NCS 2015 Shelf
DLP-L74 Mounting Multiple NCS 2015 Shelves on a Rack

Cisco NCS 2006 Specifications

General

Brand	Cisco
Model	NCS 2006
Category	Network Hardware
Language	English