CHAPTER 24
NCS 2015 Shelf Installation Acceptance Test
This chapter describes how to perform a shelf acceptance test on Cisco NCS 2015 shelf.
•
NTP-L60 Performing NCS 2015 Shelf Installation Acceptance Test, page 359
NTP-L60 Performing NCS 2015 Shelf Installation Acceptance
Test
Use this procedure to perform a shelf installation
acceptance test for the NCS 2015 shelf.
Purpose
VoltmeterTools/Equipment
NonePrerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Procedure
Step 1
If you installed an NCS 2015 shelf, complete the table below by verifying that each applicable procedure was
completed.
Cisco NCS 2000 Series Hardware Installation Guide
359
To Next Page
Loading...
