Cisco NCS 2006 - DLP-L23 Removing the Fiber Module

#1 Phillips cross-head PH screwdriverTools/Equipment
NonePrerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Procedure
Step 1
Complete DLP-L23 Removing the Fiber Module, on page 223.
Step 2
Complete DLP-L24 Installing the Cable Module, on page 224.
Step 3
Complete DLP-L25 Routing and Locking Cables, on page 225.
Stop. You have completed this procedure.
DLP-L23 Removing the Fiber Module
This procedure removes the default fiber module in
the NCS 2006 system.
Purpose
#1 Phillips cross-head PH screwdriverTools/Equipment
NonePrerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Cisco NCS 2000 Series Hardware Installation Guide
223
Connecting and Routing the Cables
DLP-L23 Removing the Fiber Module