Cisco NCS 2006 - Mounting the Cisco NCS 2002 Brackets; NTP-L44 Mounting the Brackets in ANSI Configuration

CHAPTER 5
Mounting the Cisco NCS 2002 Brackets
This chapter explains how to install the NCS 2002 brackets
The sections are:
•
NTP-L44 Mounting the Brackets in ANSI Configuration, page 45
•
NTP-L45 Mounting the Brackets in ETSI Configuration, page 51
NTP-L44 Mounting the Brackets in ANSI Configuration
This task installs the 19-inch mounting brackets to
the NCS 2002 shelf for ANSI rack configuration.
Purpose
•
#2 Phillips Dynamometric screwdriver
•
Medium slot-head screwdriver
•
Small slot-head screwdriver
Tools/Equipment
NTP-L41 Unpacking and Inspecting the Shelf, on
page 20
Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Perform these procedures as required:
•
DLP-L35 Mounting the 19-inch Brackets on the NCS 2002 Shelf for ANSI Rack Configuration, on
page 46
Cisco NCS 2000 Series Hardware Installation Guide
45