EasyManua.ls Logo

Cisco NCS 2006 - DLP-L5 Mounting the Brackets on the NCS 2006 Shelf for ETSI Rack Configuration

Cisco NCS 2006
510 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DLP-L5 Mounting the Brackets on the NCS 2006 Shelf for ETSI Rack
Configuration
This task installs the mounting brackets on the NCS
2006 shelf for ETSI rack configuration.
In an ETSI rack, the mounting brackets are
installed only in the front position.
Note
Purpose
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Tools/Equipment
DLP-L62 Unpacking and Verifying the Shelf , on
page 20
DLP-L63 Inspecting the Shelf, on page 22
Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Use only the fastening hardware provided with the NCS 2006 to prevent loosening, deterioration, and
electromechanical corrosion of the hardware and joined material.
Caution
When mounting the NCS 2006 in a frame with a nonconductive coating (such as paint, lacquer, or enamel)
either use the thread-forming screws provided with the NCS 2006 ship kit, or remove the coating from
the threads to ensure electrical continuity.
Caution
Cisco NCS 2000 Series Hardware Installation Guide
176
Mounting the Brackets on NCS 2006 Shelf
DLP-L5 Mounting the Brackets on the NCS 2006 Shelf for ETSI Rack Configuration

Table of Contents

Related product manuals