This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security. Statement
1017
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement
1022
Warning
The NCS 2002, NCS 2006, and NCS 2015 are suitable for mounting on concrete or other noncombustible
surfaces only.
Note
In this chapter, “shelf” refers to the steel enclosure that holds cards and connects power, and “node” refers
to the entire hardware and software system. Unless otherwise specified, NCS 2002, NCS 2006, and NCS
2015 refers to both ANSI and ETSI environments.
Note
The NCS 2006 is suitable for installation in network telecommunication facilities where the National
Electric Code (NEC) applies.
Note
Required Tools and Equipment
The following sections describe the tools and equipment you need to install and test the NCS 2002, NCS
2006, or NCS 2015 shelves.
Cisco Supplied Materials
The following table lists the materials that are required to install, and are shipped with the NCS 2002, NCS
2006, and NCS 2015 shelves (wrapped in plastic). The shipped quantity of each item is in parentheses.
To avoid damage during shipment, either a standard front door or a temporary front door is preinstalled
in the Cisco NCS 2006 shelves. If a front door is ordered, a standard front door is preinstalled. If a front
door is not ordered, a temporary front door is preinstalled.
Note
Cisco NCS 2000 Series Hardware Installation Guide
10
Preparing to Install the Cisco NCS 2002, NCS 2006, and NCS 2015 Shelf
Required Tools and Equipment
To Next Page
Loading...
Need help?
General
