Cisco NCS 2006 User Manual

b
Plug the other end into the M-MSM-1 port of the NCS 2015 SSC 2 that corresponds to the control card
in Slot 1.
5
Using another cross-over (CAT-5) LAN cable:
a
Plug one connector into the MSM port of the NCS 2006 NC that corresponds to the control card in
Slot 8.
b
Plug the other end into the P-MSM-1 port of the NCS 2015 SSC 2 that corresponds to the control card
in Slot 17.
6
Using a cross-over (CAT-5) LAN cable:
a
Plug one connector into the MSM port of the NCS 2006 SSC1 that corresponds to the control card in
Slot 1.
b
Plug the other end into the M-MSM-1 port of the NCS 2015 SSC 3 that corresponds to the control card
in Slot 1.
7
Using another cross-over (CAT-5) LAN cable:
a
Plug one connector into the MSM port of the NCS 2006 SSC 1 that corresponds to the control card in
Slot 8.
b
Plug the other end into the P-MSM-1 port of the NCS 2015 SSC 3 that corresponds to the control card
in Slot 17.
8
Using a multi-mode fiber optic cable:
a
Plug one connector into the M-MSM-2 port of the NCS 2015 SSC 2 that corresponds to the control
card in Slot 1.
b
Plug the other connector into the M-MSM-2 port of the NCS 2015 SSC 4 that corresponds to the control
card in Slot 1.
9
Using another multi-mode fiber optic cable:
a
Plug one connector into the P-MSM-2 port of the NCS 2015 SSC 2 that corresponds to the control
card in Slot 17.
b
Plug the other connector into the P-MSM-2 port of the NCS 2015 SSC 4 that corresponds to the control
card in Slot 17.
10
To connect a NCS 2015 or NCS 2006 SSC to a ONS 15454 SSC, use a cross-over (CAT-5) LAN cable:
a
Plug one connector into the M-MSM-1 port of NCS 2015 SSC or the MSM port of the NCS 2006 SSC
that corresponds to the control card in Slot 1.
b
Plug the other end into the RJ-45 port of the control card in Slot 7 of ONS 15454 SSC.
11
Using another cross-over (CAT-5) LAN cable:
a
Plug one connector into the P-MSM-1 port of NCS 2015 SSC or the MSM port of the NCS 2006 SSC
that corresponds to the control card in Slot 17 or Slot 8 respectively.
b
Plug the other end into the RJ-45 port of the control card in Slot 11 of ONS 15454 SSC.
12
Repeat Steps 6 through 11 to connect the remaining SSCs.
Cisco NCS 2000 Series Hardware Installation Guide
428
Multishelf Management
Cisco NCS 2006 Node Controller, and ONS 15454, NCS 2006, and NCS 2015 Subtending Shelves

Cisco NCS 2006 Specifications

General

Brand	Cisco
Model	NCS 2006
Category	Network Hardware
Language	English