Cisco NCS 2006 User Manual

•
NTP-L29 Installing the Standard Door of the
NCS 2002 Shelf, on page 108.
•
Connect the chassis to the office ground. For
detailed instructions on how to ground the
chassis, refer to the Electrostatic Discharge and
Grounding Guide for Cisco NCS 2000 Series .
Prerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
The NCS 2002 shelf has an ESD plug input and is shipped with an ESD wrist strap. The ESD plug input
is located on the outside of the shelf on the right side. It is labeled “ESD” on the top and bottom. Always
wear an ESD wrist strap and connect the strap to the ESD plug when working on the NCS 2002. For
detailed instructions on how to wear the ESD wristband, refer to the Electrostatic Discharge and Grounding
Guide for Cisco NCS 2000 Series .
Caution
Procedure
Step 1
Loosen the standard door screws (see the figure below).
Step 2
Push the latches in the opposite direction as shown in the figure below.
Figure 60: Opening the Standard Door
Cisco NCS 2000 Series Hardware Installation Guide
112
Installing the Cisco NCS 2002 Door and Other Modules
DLP-L45 Opening the Standard Door of the NCS 2002 Shelf

Cisco NCS 2006 Specifications

General

Brand	Cisco
Model	NCS 2006
Category	Network Hardware
Language	English