To avoid duplex mismatch between EMS or craft terminal port and external LAN switch port, auto
negotiation must be enabled on the external LAN switch port.
Note
Procedure
Step 1
Using 0.51 mm² or 0.64 mm² (#22 or #24 AWG) wire or a standard CAT-5 Ethernet cable, connect the wires
to the RJ-45 connector.
Step 2
Return to your originating procedure (NTP).
Cisco NCS 2000 Series Hardware Installation Guide
241
Connecting and Routing the Cables
DLP-L29 Installing LAN Wires in NCS 2006
To Next Page
Loading...
