Cisco NCS 2006 User Manual

Alarm SCSI 26-pin cable
Wire-wrap tool for BITS
Screw for the alarm cable
Tools/Equipment
NonePrerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Procedure
Step 1
Connect one end of the SCSI cable to the input alarms or input/output alarms, and the other end to the alarm
source (See the figure below ).
These alarms are generic signals that the operator assigns to a definite wire (color) and name through
the Craft Terminal.
Note
Cisco NCS 2000 Series Hardware Installation Guide
351
Connecting and Routing the Cables
DLP-L76 Installing Alarm Wires in NCS 2015

Cisco NCS 2006 Specifications

General

Brand	Cisco
Model	NCS 2006
Category	Network Hardware
Language	English