Cisco NCS 2006 User Manual

Switch(config)#no spanning-tree optimize bpdu transmission
Switch(config)#spanning-tree extend system-id
Step 2
For a 24-port catalyst switch, enter the following commands to configure Ports 1 through 23. Replace port
with the port number (1 through 23) and repeat for each port:
Example:
Switch(config)#interface FastEthernet0/
port
Switch(config-if)#switchport mode access
Switch(config-if)#switchport access vlan 2
Step 3
For a 24-port catalyst switch, enter the following commands to configure Port 24. Replace port with the port
number.
Example:
Switch(config)#interface FastEthernet0/
port
Switch(config-if)#switchport mode access
Step 4
Enter the following interface commands:
Example:
Switch(config)#interface GigabitEthernet0/1
Switch(config)#no ip address
Switch(config)#ip http server
Switch(config)#interface GigabitEthernet0/2
Switch(config)#no ip address
Switch(config)#ip http server
Switch(config)#interface Vlan 1
Switch(config)#no ip address
Switch(config)#no ip route-cache
Switch(config)#ip http server
Step 5
Enter the following commands to configure authentication:
Example:
Switch(config)#line con 0
Switch(config)#line vty 0 4
Switch(config-line)#password yyyyyy
Switch(config-line)#login
Switch(config-line)#line vty 5 15
Switch(config-line)#password yyyyyy
Switch(config-line)#login
Switch(config-line)#end
Cisco NCS 2000 Series Hardware Installation Guide
414
Multishelf Management
NTP-L63 Configure a Cisco Catalyst 3560 (Active and Standby) for a Multishelf Node

Cisco NCS 2006 Specifications

General

Brand	Cisco
Model	NCS 2006
Category	Network Hardware
Language	English