Example:
Router(config)#interface FastEthernet9
(Router(config-if)no ip address
(Router(config-if)no ip route-cache
Router(config)#interface FastEthernet9.2
(Router(config-if)dot1Q
public VLAN ID
native
(Router(config-if)no ip route-cache
(Router(config-if)no snmp trap link-status
(Router(config-if)bridge-group
public VLAN ID
Router(config)#interface FastEthernet9.2
(Router(config-if)encapsulation dot1Q
private VLAN ID
(Router(config-if)no ip route-cache
(Router(config-if)no snmp trap link-status
(Router(config-if) bridge-group
private VLAN ID
Step 5
Enter the following commands to configure port PRT (port 10):
Example:
Router(config)# interface FastEthernet10
(Router(config-if)no ip address
(Router(config-if)no ip route-cache
Router(config)#interface FastEthernet10.1
(Router(config-if)encapsulation dot1Q
public VLAN ID
native
(Router(config-if)no ip route-cache
(Router(config-if)no snmp trap link-status
(Router(config-if)bridge-group
public VLAN ID
(Router(config-if)bridge-group public VLAN ID priority 0
!
Router(config)#interface FastEthernet10.2
(Router(config-if)encapsulation dot1Q
private VLAN ID
(Router(config-if)no ip route-cache
(Router(config-if)no snmp trap link-status
(Router(config-if)bridge-group
private VLAN ID
(Router(config-if)bridge-group
private VLAN ID
priority 0
Router(config)#interface FastEthernet11
Router(config)# no ip address
Router(config)#no ip route-cache
Router(config)# shutdown
Step 6
Enter the following interface commands:
Example:
(Router(config)# interface POS0
(Router(config)# no ip address
(Router(config)# no ip route-cache
(Router(config)# shutdown
(Router(config)# crc 32
(Router(config)# interface POS1
(Router(config)# no ip address
(Router(config)# no ip route-cache
(Router(config)# shutdown
Cisco NCS 2000 Series Hardware Installation Guide
419
Multishelf Management
NTP-L65 Configure the MS-ISC-100T Card for a ONS 15454 Multishelf Node for Non-Default Public and Private VLAN
IDs
To Next Page
Loading...
