6
Using a cross-over (CAT-5) LAN cable:
a
Plug one connector into the MSM port of the NCS 2006 SSC 1 that corresponds to the control card in
Slot 1.
b
Plug the other end into the M-MSM-1 port of the NCS 2015 SSC 3 that corresponds to the control card
in Slot 1.
7
Using another cross-over (CAT-5) LAN cable:
a
Plug one connector into the MSM port of the NCS 2006 SSC 1 that corresponds to the control card in
Slot 8.
b
Plug the other end into the P-MSM-1 port of the NCS 2015 SSC 3 that corresponds to the control card
in Slot 17.
8
Using a cross-over (CAT-5) LAN cable:
a
Plug one connector into the M-MSM-1 port of the NCS 2015 SSC 2 that corresponds to the control
card in Slot 1.
b
Plug the other end into the MSM port of the NCS 2006 SSC 4 that corresponds to the control card in
Slot 1.
9
Using another cross-over (CAT-5) LAN cable:
a
Plug one connector into the P-MSM-1 port of the NCS 2015 SSC 2 that corresponds to the control
card in Slot 17.
b
Plug the other end into the MSM port of the NCS 2006 SSC 4 that corresponds to the control card in
Slot 8.
10
To connect a NCS 2015 or NCS 2006 SSC to a ONS 15454 SSC:
a
Using a cross-over (CAT-5) LAN cable, plug one connector into the M-MSM-1 port of NCS 2015
SSC or the MSM port of the NCS 2006 SSC that corresponds to the control card in Slot 1.
b
Plug the other end into the RJ-45 port of the control card in Slot 7 of ONS 15454 SSC.
c
Using another cross-over (CAT-5) LAN cable, plug one connector into the P-MSM-1 port of NCS
2015 SSC or the MSM port of the NCS 2006 SSC that corresponds to the control card in Slot 17 or
Slot 8 respectively.
d
Plug the other end into the RJ-45 port of the control card in Slot 11 of ONS 15454 SSC.
11
Repeat the above steps to connect the remaining SSCs in a daisy chain.
Cisco NCS 2000 Series Hardware Installation Guide
425
Multishelf Management
Cisco NCS 2015 Node Controller, ONS 15454, NCS 2006, and NCS 2015 as Subtending Shelves
To Next Page
Loading...
