Extreme Networks EAS 100-24t Switch CLI User Manual

Chapter 4: Management
Extreme Networks EAS 100-24t Switch CLI Manual
104
Example usage:
To delete an IPv6 address of the System interface:
Example usage:
To enable the automatic configuration of a link local address for an interface:
Parameters <ipv6networkaddr> - Specifies the IPv6 network address.
Restrictions Only Administrator-level users can issue this command.
#delete ipif System ipv6address FE80::200:1FF:FE02:303/128
Command: delete ipif System ipv6address FE80::200:1FF:FE02:303/128
Success.
#
enable ipif_ipv6_link_local_auto
Purpose Used to enable the auto configuration of a link local address when no IPv6
address is configured.
Syntax enable ipif_ipv6_link_local_auto [System]
Description This command is used to enable the auto configuration of a link local address
when there are no IPv6 addresses explicitly configured. When an IPv6
address is explicitly configured, the link local address will be automatically
configured, and the IPv6 processing will start. When there is no IPv6 address
explicitly configured, by default, a link local address is not configured and the
IPv6 processing will be disabled. By enabling this automatic configuration, the
link local address will be automatically configured and the IPv6 processing will
start.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#enable ipif_ipv6_link_local_auto System
Command: enable ipif_ipv6_link_local_auto System
Success.
#
disable ipif_ipv6_link_local_auto
Purpose Used to disable the auto configuration of a link local address when no IPv6
address is configured.
Syntax disable ipif_ipv6_link_local_auto [System]
Description This command is used to disable the auto configuration of a link local address
when no IPv6 address is explicitly configured.
delete ipif

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English