Extreme Networks EAS 100-24t Switch CLI - Management

Extreme Networks EAS 100-24t Switch CLI Manual
41
CHAPTER
4
Management
Command History Commands
The Command History commands in the CLI are listed (along with the appropriate parameters) in the
following table:
Each command is listed, in detail, in the following sections:
Command Parameters
? ? {<command>}
dir
config command_history <value 1-40>
show command_history
?
Purpose Used to display all commands in the CLI.
Syntax ? {<command>}
Description This command is used to display all of the commands available through the
CLI.
Parameters {<command>} – Entering the question mark with an appropriate command will
list all the corresponding parameters for the specified command, along with a
brief description of the commands function and similar commands having the
same words in the command.
Restrictions None.