Extreme Networks EAS 100-24t Switch CLI User Manual

SMTP Commands
Extreme Networks EAS 100-24t Switch CLI Manual
107
● If the initial message sent to a mail recipient is not delivered, it will be placed in the waiting queue
until its place in the queue has been reached, and then another attempt to transmit the message is
made.
● The maximum number of attempts for delivering mail to a recipient is three. Mail message delivery
attempts will be tried every five minutes until the maximum number of attempts is reached. Once
reached and the message has not been successfully delivered, the message will be dropped and not
received by the mail recipient.
If the switch shuts down or reboots, mail messages in the waiting queue will be lost.
The SMTP commands in the CLI are listed (along with the appropriate parameters) in the following
table:
Each command is listed, in detail, in the following sections:
Example usage:
To enable SMTP on the switch:
Command Parameters
enable smtp
disable smtp
config smtp {server <ipaddr> | server_port <tcp_port_number 1-65535> | self_mail_addr
<mail_addr 64> | [add mail_receiver <mail_addr 64> | delete mail_receiver
<index 1-8>]}
show smtp
smtp send_testmsg
enable smtp
Purpose Used to enable the switch as a SMTP client.
Syntax enable smtp
Description This command, in conjunction with the disable smtp command will enable
and disable the switch as a SMTP client without changing configurations.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#enable smtp
Command: enable smtp
Success.
#
disable smtp
Purpose Used to disable the switch as a SMTP client.

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English