Chapter 1: Introduction
Extreme Networks EAS 100-24t Switch CLI Manual
10
Figure 8: The Next Available Commands Prompt
The top-level commands consist of commands such as show or config. Most of these commands require
one or more parameters to narrow the top-level command.
For example, if users enter the show command with no additional parameters, the CLI will then display
all of the next possible parameters.
Figure 9: Next possible completions: Show Command
#the
Available commands:
.. ? cable_diag clear
config create delete dir
disable download enable login
logout ping ping6 reboot
reset save show smtp
telnet traceroute upload
#
#show
Command: show
Next possible completions:
802.1p 802.1x access_profile account
acct_client arpentry asymmetric_vlan auth_client
auth_diagnostics auth_session_statistics auth_statistics
authen authen_enable authen_login authen_policy
authentication authorization bandwidth_control command_history
config cos dhcp_relay
dot1v_protocol_group dscp_mapping error
fdb firmware flow_meter greeting_message
gvrp igmp_snooping ipif
ipif_ipv6_link_local_auto iproute ipv6
ipv6route jumbo_frame lacp_ports link_aggregation
lldp log log_save_timing loopdetect
mac_based_access_control mac_based_access_control_local
mac_based_vlan mirror mld_snooping multicast
multicast_fdb packet port port_security
ports pvid qinq radius
router_ports scheduling scheduling_mechanism
serial_port session smtp snmp
sntp ssh ssl stp
switch syslog tech_support terminal_line
time traffic traffic_segmentation
trusted_host utilization vlan vlan_translation
#
To Next Page
Loading...
