Extreme Networks EAS 100-24t Switch CLI - Delete Stp Instance_Id

Chapter 5: Layer 2 Features
Extreme Networks EAS 100-24t Switch CLI Manual
162
Example usage:
To configure instance ID 2 to add VID 10:
Example usage:
To remove VID 10 from instance ID 2:
Parameters <value 1-4> Enter a value between 1 and 4 to identify the Spanning Tree
instance on the switch.
Restrictions Only Administrator-level users can issue this command.
#config stp instance_id 2 add_vlan 10
Command: config stp instance_id 2 add_vlan
10
Success.
#
#config stp instance_id 2 remove_vlan 10
Command: config stp instance_id 2
remove_vlan 10
Success.
#
delete stp instance_id
Purpose Used to delete a STP instance ID from the switch.
Syntax delete stp instance_id <value 1-4>
Description This command is used to delete a previously configured STP instance ID from
the switch.
Parameters <value 1-4> - Enter a value between 1 and 4 to identify the Spanning Tree
instance on the switch.
Restrictions Only Administrator-level users can issue this command.
config stp instance_id