Chapter 5: Layer 2 Features
Extreme Networks EAS 100-24t Switch CLI Manual
168
Example usage:
To display the STP instance configuration for instance 0 (the internal CIST) on the switch:
#show stp instance 0
Command: show stp instance 0
STP Instance Settings
---------------------------
Instance Type : CIST
Instance Status : Enabled
Instance Priority : 32768(Bridge Priority : 32768, sys ID ext : 0 )
STP Instance Operational Status
--------------------------------
Designated Root Bridge : 32766/00-90-27-39-78-E2
External Root Cost : 200012
Regional Root Bridge : 32768/00-53-13-1A-33-24
Internal Root Cost : 0
Designated Bridge : 32768/00-50-BA-71-20-D6
Root Port : 1
Max Age : 20
Forward Delay : 15
Last Topology Change : 856
Topology Changes Count : 2987
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show stp mst_config_id
Purpose Used to display the MSTP configuration identification.
Syntax show stp mst_config_id
Description This command is used to display the switch’s current MSTP configuration
identification.
Parameters None.
Restrictions None.
To Next Page
Loading...
