SSL Commands
Extreme Networks EAS 100-24t Switch CLI Manual
301
Example usage:
To set the SSL cachetimeout for 7200 seconds:
Example usage:
To view the SSL cache timeout on the switch:
Description This command is used to set the time between a new key exchange between
a client and a host using the SSL function. A new SSL session is established
every time the client and host go through a key exchange. Specifying a longer
timeout will allow the SSL session to reuse the master key on future
connections with that particular host, therefore speeding up the negotiation
process.
Parameters cachetimeout <value 60-86400> - Enter a timeout value between 60 and
86400 seconds to specify the total time an SSL key exchange ID stays valid
before the SSL module will require a new, full SSL negotiation for connection.
The default cache timeout is 600 seconds
Restrictions Only Administrator-level users can issue this command.
#config ssl cachetimeout timeout 7200
Command: config ssl cachetimeout timeout 7200
Success.
#
show ssl cachetimeout
Purpose Used to show the SSL cache timeout.
Syntax show ssl cachetimeout
Description This command is used to view the SSL cache timeout currently implemented
on the switch.
Parameters None.
Restrictions None.
#show ssl cachetimeout
Command: show ssl cachetimeout
Cache timeout is 600 second(s).
#
show ssl
Purpose Used to view the SSL status and the certificate file status on the switch.
Syntax show ssl {certificate}
config ssl cachetimeout
To Next Page
Loading...
Need help?
General
