Extreme Networks EAS 100-24t Switch CLI - Show Stp Instance

Multiple Spanning Tree Protocol (MSTP) Commands
Extreme Networks EAS 100-24t Switch CLI Manual
167
Example usage:
To show STP ports information for port 1 (STP enabled on switch):
Parameters <portlist> - Specifies a port or range of ports to be viewed. Information for a
single port is displayed. If no ports are specified the STP information for port 1
will be displayed. Users may use the Space bar, p and n keys to view
information for the remaining ports.
instance <value 0-4> - Enter a value between 0 and 4 corresponding to the
previously configured instance_id of which the user wishes to show the
specified ports' setting. An instance id of 0 denotes the default instance_id
(CIST) internally set on the switch.
Restrictions None.
#show stp ports
Command: show stp ports
MSTP Port Information
----------------------
Port Index : 1 , Hello Time: 2 /2 , Port STP Enabled ,
Restricted role : False, Restricted TCN : False
External PathCost : Auto/200000 , Edge Port : Auto /No , P2P : Auto /Yes
Port Forward BPDU : Enabled
MSTI Designated Bridge Internal PathCost Prio Status Role
----- ------------------ ----------------- ---- ---------- ----------
0 N/A 200000 128 Disabled Disabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show stp instance
Purpose Used to display the switch’s STP instance configuration
Syntax show stp instance {<value 0-4>}
Description This command is used to display the switch’s current STP Instance Settings
and the STP Instance Operational Status.
Parameters <value 0-4> - Enter a value defining the previously configured instance_id on
the switch. An entry of 0 will display the STP configuration for the CIST
internally set on the switch.
Restrictions None
show stp ports