Extreme Networks EAS 100-24t Switch CLI - Show Stp

Multiple Spanning Tree Protocol (MSTP) Commands
Extreme Networks EAS 100-24t Switch CLI Manual
165
Example usage:
To designate ports 1 through 5, with instance id 2, to have an auto internalCost and a priority of 16:
Example usage:
To display the status of STP on the switch:
Status 1: STP enabled with STP compatible version
#config stp mst_ports 1-5 instance_id 2 internalCost auto priority 16
Command : config stp mst_ports 1-5 instance_id 2 internalCost auto priority 16
Success.
#
show stp
Purpose Used to display the switch’s current STP configuration.
Syntax show stp
Description This command is used to display the switch’s current STP configuration.
Parameters None
Restrictions None.
#show stp
Command: show stp
STP Bridge Global Settings
---------------------------
STP Status : Enabled
STP Version : STP compatible
Max Age : 20
Hello Time : 2
Forward Delay : 15
Max Hops : 20
TX Hold Count : 6
Forwarding BPDU : Enabled
#