Extreme Networks EAS 100-24t Switch CLI - Switch Utility Commands

Switch Utility Commands
Extreme Networks EAS 100-24t Switch CLI Manual
31
Example usage:
To display jumbo frame:
Switch Utility Commands
The Switch Utility commands in the CLI are listed (along with the appropriate parameters) in the
following table:
Each command is listed, in detail, in the following sections:
show jumbo_frame
Purpose Used to display the current configuration of jumbo frame.
Syntax show jumbo_frame
Description This command is used to display the current configuration of the jumbo frame
setting.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#show jumbo_frame
Command: show jumbo_frame
Jumbo Frame State : Enabled
Maximum Jumbo Frame Size : 9216 Bytes
#
Command Parameters
download [firmware_fromTFTP [<ipaddr> | <ipv6addr>] <path_filename 64> image_id
<value 1-2> | cfg_fromTFTP [<ipaddr> | <ipv6addr>] <path_filename 64>
{increment}]
config firmware image_id <value 1-2> [delete | boot_up]
show firmware information
show config [current_config | config_in_nvram]
upload [cfg_toTFTP | log_toTFTP] [<ipaddr> | <ipv6addr>] <path_filename 64>
ping <ipaddr> {times <value 0-255> | size <value 1-60000> | timeout <sec 1-99>}
ping6 <ipv6addr> {times <value 1-255> | size <value 1-6000> | timeout <value 1-10>}
traceroute <ipaddr> {ttl <value 1-60> | port <value 30000-64900> | timeout <sec 1-65535>
| probe <value 1-9>}
config terminal_line [default | <value 20-80>]
show terminal_line
download
Purpose Used to download and install new firmware or a switch configuration file from
a TFTP server.