Extreme Networks EAS 100-24t Switch CLI - Config Authen Server_Host

Access Authentication Control Commands
Extreme Networks EAS 100-24t Switch CLI Manual
269
Example usage:
To create a TACACS+ authentication server host, with port number 1234, a timeout value of 10 seconds
and a retransmit count of 5.
Parameters server_host <ipaddr> - The IP address of the remote server host to add.
protocol – The protocol used by the server host. The user may choose one of
the following:
tacacs – Enter this parameter if the server host utilizes the TACACS protocol.
xtacacs - Enter this parameter if the server host utilizes the XTACACS
protocol.
tacacs+ - Enter this parameter if the server host utilizes the TACACS+
protocol.
radius - Enter this parameter if the server host utilizes the RADIUS protocol.
port <int 1-65535> - Enter a number between 1 and 65535 to define the virtual
port number of the authentication protocol on a server host. The default port
number is 49 for TACACS/XTACACS/TACACS+ servers and 1812 and 1813
for RADIUS servers but the user may set a unique port number for higher
security.
key <key_string 254> - Authentication key to be shared with a configured
TACACS+ or RADIUS server only. Specify an alphanumeric string up to 254
characters.
timeout <int 1-255> - Enter the time in seconds the switch will wait for the
server host to reply to an authentication request. The default value is 5
seconds.
retransmit <int 1-255> - Enter the value in the retransmit field to change how
many times the device will resend an authentication request when the server
does not respond.
Restrictions Only Administrator-level users can issue this command.
#create authen server_host 10.1.1.121 protocol tacacs+ port 1234 timeout 10
retransmit 5
Command: create authen server_host 10.1.1.121 protocol tacacs+ port 1234 timeout 10
retransmit 5
Success.
#
config authen server_host
Purpose Used to configure a user-defined authentication server host.
Syntax config authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ |
radius] {port <int 1-65535> | key [<key_string 254> | none] | timeout <int
1-255> | retransmit <int 1-255>}
create authen server_host