Extreme Networks EAS 100-24t Switch CLI - Disable Dhcp_Relay; Enable Dhcp_Relay; LLDP Commands

LLDP Commands
Extreme Networks EAS 100-24t Switch CLI Manual
47
Example usage
To enable DHCP relay:
Example usage
To disable DHCP relay:
LLDP Commands
The LLDP commands in the CLI are listed (along with the appropriate parameters) in the following
table:
enable dhcp_relay
Purpose Used to enable the DHCP/BOOTP relay function on the switch.
Syntax enable dhcp_relay
Description This command is used to enable the DHCP/BOOTP relay function on the
switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#enable dhcp_relay
Command: enable dhcp_relay
Success.
#
disable dhcp_relay
Purpose Used to disable the DHCP/BOOTP relay function on the switch.
Syntax disable dhcp_relay
Description This command is used to disable the DHCP/BOOTP relay function on the
switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#disable dhcp_relay
Command: disable dhcp_relay
Success.
#
Command Parameters
enable lldp