Extreme Networks EAS 100-24t Switch CLI - Show Snmp View

Chapter 4: Management
Extreme Networks EAS 100-24t Switch CLI Manual
72
Example usage:
To delete a previously configured SNMP view from the switch:
Description This command is used to remove an SNMP view previously created on the
switch.
Parameters <view_name 32> - An alphanumeric string of up to 32 characters that
identifies the SNMP view to be deleted.
all - Specifies that all of the SNMP views on the switch will be deleted.
<oid> - The object ID that identifies an object tree (MIB tree) that will be
deleted from the switch.
Restrictions Only Administrator-level users can issue this command.
#delete snmp view exnview all
Command: delete snmp view exnview all
Success.
#
show snmp view
Purpose Used to display an SNMP view previously created on the switch.
Syntax show snmp view {<view_name 32>}
Description This command is used to display an SNMP view previously created on the
switch.
Parameters <view_name 32> - An alphanumeric string of up to 32 characters that
identifies the SNMP view that will be displayed.
Restrictions None.
delete snmp view