Extreme Networks EAS 100-24t Switch CLI - Clear Counters

Network Monitoring Commands
Extreme Networks EAS 100-24t Switch CLI Manual
93
Example usage:
To display the port utilization statistics:
Example usage:
To clear the counters:
#show utilization ports
Command: show utilization ports
Port TX/sec RX/sec Util Port TX/sec RX/sec Util
---- ---------- ---------- ---- ---- ---------- ---------- ----
1 0 0 0 22 0 0 0
2 0 0 0 23 0 0 0
3 0 0 0 24 0 0 0
4 0 0 0
5 0 0 0
6 0 0 0
7 0 37 1
8 0 0 0
9 0 0 0
10 0 0 0
11 36 0 1
12 0 0 0
13 0 0 0
14 0 0 0
15 0 0 0
16 0 0 0
17 0 0 0
18 0 0 0
19 0 0 0
20 0 0 0
21 0 0 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
clear counters
Purpose Used to clear the switch’s statistics counters.
Syntax clear counters {ports <portlist>}
Description This command is used to clear the counters used by the switch to compile
statistics.
Parameters <portlist> - Specifies a port or range of ports to be displayed.
Restrictions Only Administrator-level users can issue this command.
#clear counters ports 2-9
Command: clear counters ports 2-9
Success.
#