Extreme Networks EAS 100-24t Switch CLI User Manual

Chapter 3: Fundamentals
Extreme Networks EAS 100-24t Switch CLI Manual
16
Example usage:
To configure the IP interface System:
Example usage:
To display IP interface settings.
Basic Switch Commands
The Basic switch commands in the CLI are listed (along with the appropriate parameters) in the
following table:
#config ipif System ipaddress 10.48.74.122/8
Command: config ipif System ipaddress 10.48.74.122/8
Success.
#
show ipif
Purpose Used to display the configuration of an IP interface on the switch.
Syntax show ipif
Description This command will display the configuration of an IP interface on the switch.
Parameters None.
Restrictions None.
#show ipif
Command: show ipif
IP Interface Settings
Interface Name : System
IP Address : 0.0.0.0 (MANUAL)
Subnet Mask : 0.0.0.0
VLAN Name : default
Admin. State : Enabled
Link Status : Link DOWN
Member Ports : 1-24
Total Entries : 1
#
Command Parameters
create account [admin | user] <username 15>
config account <username>
show account

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English