Extreme Networks EAS 100-24t Switch CLI - Show Link_Aggregation

Chapter 5: Layer 2 Features
Extreme Networks EAS 100-24t Switch CLI Manual
140
Example usage:
To configure link aggregation algorithm for mac-source-dest:
Parameters mac_source - Indicates that the switch should examine the MAC source
address.
mac_destination - Indicates that the switch should examine the MAC
destination address.
mac_source_dest - Indicates that the switch should examine the MAC source
and destination addresses
ip_source - Indicates that the switch should examine the IP source address.
ip_destination - Indicates that the switch should examine the IP destination
address.
ip_source_dest - Indicates that the switch should examine the IP source and
destination addresses
Restrictions Only Administrator-level users can issue this command.
#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
#
show link_aggregation
Purpose Used to display the current link aggregation configuration on the switch.
Syntax show link_aggregation {group_id <value> | algorithm}
Description This command is used to display the current link aggregation configuration of
the switch.
Parameters <value> - Specifies the group ID. The switch allows up to 8 link aggregation
groups to be configured. The group number identifies each of the groups.
algorithm - Allows users to specify the display of link aggregation by the
algorithm in use by that switch.
Restrictions None.
config link_aggregation algorithm