Chapter 5: Layer 2 Features
Extreme Networks EAS 100-24t Switch CLI Manual
144
Example usage
To set the loopback detection status to enabled:
Example usage:
To enable loopback detection on the switch:
# config loopdetect ports 1-5 state enable
Command: config loopdetect ports 1-5 state enable
Success.
#
enable loopdetect
Purpose Used to globally enable the loopback detection function on the switch.
Syntax enable loopdetect
Description This command is used to allow the loopback detection function to be globally
enabled on the switch. The default value is disabled.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
# enable loopdetect
Command: enable loopdetect
Success.
#
disable loopdetect
Purpose Used to globally disable the loopback detection on the switch.
Syntax disable loopdetect
Description This command is used to globally disable the loopback detection on the
switch. The default value is disabled.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
To Next Page
Loading...
