Extreme Networks EAS 100-24t Switch CLI - Only Administrator-Level Users Can Issue this Command; Parameters

Chapter 4: Management
Extreme Networks EAS 100-24t Switch CLI Manual
50
Example usage
To change the packet transmission interval:
To change the multiplier value:
To configure the delay-interval interval:
To change the re-initialization delay interval:
Parameters message_tx_interval - Changes the interval between consecutive
transmissions of LLDP advertisements on any given port. The range is from 5
to 32768 seconds. The default setting is 30 seconds.
message_tx_hold_multiplier - The range is from 2 to 10. The default setting 4.
tx_delay - The range is from 1 second to 8192 seconds. The default setting 2
seconds.
reinit_delay - The range is from 1 second to 10 seconds. The default setting 2
seconds.
Restrictions Only Administrator-level users can issue this command.
# config lldp message_tx_interval 30
Command: config lldp message_tx_interval 30
Success.
#
# config lldp message_tx_hold_multiplier 3
Command: config lldp message_tx_hold_multiplier 3
Success.
#
# config lldp tx_delay 8
Command: config lldp tx_delay 8
Success.
#
# config lldp reinit_delay 5
Command: config lldp reinit_delay 5
Success.
#
config lldp