Extreme Networks EAS 100-24t Switch CLI - Show Igmp_Snooping Group

Chapter 5: Layer 2 Features
Extreme Networks EAS 100-24t Switch CLI Manual
136
Example usage:
To display the router ports.
Example usage:
To view the current IGMP snooping group:
#show router_ports
Command: show router_ports
VLAN Name : default
Static Router Port :
Dynamic Router Port:
Forbidden Router Port:
Total Entries: 1
#
show igmp_snooping group
Purpose Used to display the current IGMP snooping group configuration on the switch.
Syntax show igmp_snooping group {[vlan <vlan_name 32> | vlanid <vidlist>]}
Description This command will display the current IGMP snooping group configuration on
the switch.
Parameters <vlan_name 32> - The name of the VLAN for which to view IGMP snooping
group information.
<vidlist> - The VID list for which to view IGMP snooping group information.
Restrictions None.
#show igmp_snooping group
Command: show igmp_snooping group
Source/Group : NULL/239.255.255.255
VLAN Name/VID : default/1
Reports : 1
Member Ports : 4
Router Ports : 8
Up time : 122
Expire Time : 260
Filter Mode : EXCLUDE
Total Entries : 1
#