Extreme Networks EAS 100-24t Switch CLI - Show Lldp Local_Ports

LLDP Commands
Extreme Networks EAS 100-24t Switch CLI Manual
59
Example usage
To display the LLDP per port TLV option configuration:
# show lldp ports 1
Command: show lldp ports 1
Port ID : 1
-----------------------------------------------------------------
Admin Status : TX_and_RX
Notification Status : Disable
Advertised TLVs Option :
Port Description Disable
System Name Disable
System Description Disable
System Capabilities Disable
Enabled Management Address
(NONE)
Port VLAN ID Disable
Enabled Port_and_protocol_VLAN_ID
(NONE)
Enabled VLAN Name
(NONE)
Enabled Protocol_identity
(NONE)
MAC/PHY Configuration/Status Disable
Power Via MDI Disable
Link Aggregation Disable
Maximum Frame Size Disable
#
show lldp local_ports
Purpose Used to display the per-port information currently available for populating
outbound LLDP advertisements.
Syntax show lldp local_ports {<portlist>} {mode [brief | normal | detailed]}
Description This command is used to display the per-port information currently available
for populating outbound LLDP advertisements.
Parameters <portlist> - Specify a range of ports to be configured.
When a port list is not specified, information for all ports will be displayed.
brief - Display the information in brief mode.
normal - Display the information in normal mode. This is the default display
mode.
detailed - Display the information in detailed mode.
Restrictions None.