Extreme Networks EAS 100-24t Switch CLI - Port Security Commands

Chapter 5: Layer 2 Features
Extreme Networks EAS 100-24t Switch CLI Manual
176
Port Security Commands
The Port Security commands in the CLI are listed (along with the appropriate parameters) in the
following table:
Each command is listed, in detail, in the following sections:
Command Parameters
config port_security ports [<auth_portlist> | all] {admin_state [enable | disable] | max_learning_addr
<max_lock_no 0-64> | lock_address_mode [DeleteOnTimeout |
DeleteOnReset | Permanent]}
delete port_security_entry
vlan_name
<vlan_name 32> mac_address <macaddr> port <auth_port>
clear port_security_entry port <auth_portlist>
show port_security {ports <auth_portlist>}
config port_security ports
Purpose Used to configure port security settings.
Syntax config port_security ports [<auth_portlist> | all] {admin_state [enable |
disable] | max_learning_addr <max_lock_no 0-64> | lock_address_mode
[DeleteOnTimeout | DeleteOnReset | Permanent]}
Description This command is used to configure the port security feature. Only the ports
listed in the <auth_portlist> are affected.
Parameters <auth_portlist> - Specifies a port or range of ports to be configured.
all - Configure port security for all ports on the switch.
admin_state [enable | disable] - Enable or disable port security for the listed
ports.
max_learning_addr <max_lock_no 0-64> - Use this to limit the number of
MAC addresses dynamically listed in the FDB for the ports.
lock_address_mode [DeleteOnTimout | DeleteOnReset | Permanent] -
Indicates the method of locking addresses. The user has three choices:
DeleteOnTimeout – The locked addresses will age out after the aging timer
expires (Aging Time is set using the FDB command).
DeleteOnReset – The locked addresses will not age out until the switch has
been reset.
Permanent – The locked addresses will not age out.
Restrictions Only Administrator-level users can issue this command.