Extreme Networks EAS 100-24t Switch CLI - Show Lldp Remote_Ports

LLDP Commands
Extreme Networks EAS 100-24t Switch CLI Manual
61
To display outbound LLDP advertisements for specific ports in normal mode:
To display outbound LLDP advertisements for specific ports in brief mode:
show lldp local_ports 1 mode normal
Command: show lldp local_ports 1 mode normal
Port ID : 1
-------------------------------------------------------------------------
Port Id Subtype : Local
Port Id : 1/1
Port Description : Extreme Networks EAS 100-24t R1.00
Port 1
Port VLAN ID : 1
Management Address Count : 1
PPVID Entries Count : 0
VLAN Name Entries Count : 1
Protocol Identity Entries Count : 0
MAC/PHY Configuration/Status : (See detail)
Power Via MDI : (See detail)
Link Aggregation : (See detail)
Maximum Frame Size : 1536
#
#show lldp local_ports 1 mode brief
Command: show lldp local_ports 1 mode brief
Port ID : 1
-------------------------------------------------------------------------
Port Id Subtype : Local
Port Id : 1/1
Port Description : Extreme Networks EAS 100-24t R1.00
Port 1
#
show lldp remote_ports
Purpose Used to display the information learned from the neighbor.
Syntax show lldp remote_ports {<portlist>} {mode [brief | normal | detailed]}
Description This command is used to display the information learned from the neighbor
parameters.
A maximum of 32 VLAN Name entries and 10 Management Address entries
can be received.
Parameters <portlist> - Specify a range of ports to be configured.
When a port list is not specified, information for all ports will be displayed.
brief - Display the information in brief mode.
normal - Display the information in normal mode. This is the default display
mode.
detailed - Display the information in detailed mode.