Extreme Networks EAS 100-24t Switch CLI - Enable Pvid Auto_Assign

Chapter 5: Layer 2 Features
Extreme Networks EAS 100-24t Switch CLI Manual
194
Example usage:
To add an additional port to a previously configured VLAN on the switch:
Example usage:
To enable auto-assignment of PVID:
Parameters <vidlist> - Specifies a range of multiple VLAN IDs to be configured.
tagged - Specifies the additional ports as tagged.
untagged - Specifies the additional ports as untagged.
forbidden - Specifies the additional ports as forbidden.
<portlist> - A range of ports to add to the VLAN.
advertisement - Entering the advertisement parameter specifies if the port
should join GVRP or not. There are two parameters:
enable - Specifies that the port should join GVRP.
disable - Specifies that the port should not join GVRP.
name - Entering the name parameter specifies the name of the VLAN to be
modified.
<vlan_name 32> - Enter a name for the VLAN
Restrictions Only Administrator-level users can issue this command.
#config vlan vlanid 5 add tagged 7 advertisement enable name RG
Command: config vlan vlanid 5 add tagged 7 advertisement enable name RG
Success.
#
enable pvid auto_assign
Purpose Used to enable auto-assignment of PVID.
Syntax enable pvid auto_assign
Description This command is used to enable auto-assignment of PVID.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#enable pvid auto_assign
Command: enable pvid auto_assign
Success.
#
config vlan vlanid