Extreme Networks EAS 100-24t Switch CLI User Manual

LLDP Commands
Extreme Networks EAS 100-24t Switch CLI Manual
49
Example usage
To enable LLDP:
Example usage
To disable LLDP:
# enable lldp
Command: enable lldp
Success.
#
disable lldp
Purpose Used to disable LLDP operation on the switch.
Syntax disable lldp
Description This command is used to stop the sending and receiving of LLDP
advertisement packets.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
# disable lldp
Command: disable lldp
Success.
#
config lldp
Purpose This command is used to configure the LLDP settings for this switch.
Syntax config lldp [message_tx_interval <sec 5-32768> |
message_tx_hold_multiplier <int 2-10> | tx_delay <sec 1-8192> |
reinit_delay <sec 1-10>]
Description This command is used to control how often active ports retransmit
advertisements to their neighbors. A multiplier on the msgTxInterval that is
used to compute the TTL value of txTTL in an LLDPDU. TheTTL will be
carried in the LLDPDU packet. The lifetime will be the minimum of 65535 and
(message_tx_interval * message_tx_hold_multiplier). At the partner switch,
when the time-to-Live for a given advertisement expires, the advertised data is
deleted from the neighbor switch’s MIB.
To change the minimum time (delay-interval) of any LLDP port. It will delay
advertising successive LLDP advertisements due to a change in LLDP MIB
content. The Tx delay defines the minimum interval between the sending of
LLDP messages due to constant changes of MIB content.
An re-enabled LLDP port will wait for reinit_delay after last disable command
before reinitializing

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English