Extreme Networks EAS 100-24t Switch CLI - Enable Mld_Snooping; Disable Mld_Snooping

Chapter 5: Layer 2 Features
Extreme Networks EAS 100-24t Switch CLI Manual
152
Example usage:
To set up port range 1 to 10 to be forbidden router ports:
Example usage:
To enable MLD snooping on the switch:
#config mld_snooping mrouter_ports_forbidden default add 1-10
Command: config mld_snooping mrouter_ports_forbidden default add 1-10
Success.
#
enable mld_snooping
Purpose Used to enable MLD snooping on the switch.
Syntax enable mld_snooping
Description This command is used to enable MLD snooping on the switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
# enable mld_snooping
Command: enable mld_snooping
Success.
#
disable mld_snooping
Purpose Used to disable MLD snooping on the switch.
Syntax disable mld_snooping
Description This command is used to disable MLD snooping on the switch. Disabling MLD
snooping allows all MLD and IPv6 multicast traffic to flood within a switch by
default.
Parameters None.
Restrictions Only Administrator-level users can issue this command.